#Heating iunit stabilizers free#

The decoratory case of the device consists of two side 9, front 10 and upper walls 11. The heat recovery system with furnace is covered with effective metal-clad outside surface thermal insulation. The gas-pressure reducer is attached to the spray header and flame-igniter by pipelines.

The spray header gas delivery is made through gas pressure regulator (autogenous automatic equipment) 8 with piezo-element fixed on it.

The frontal leaf is attached to heat recovery system in such a way that burners and working parts flame-igniter block are placed into furnace, and the spray header along with thermal couple lead and thermogenerating room, are out of furnace. The flame-igniter (pilot burner) 6 block is also attached to the frontal leaf, consisting of actually igniter, and thermocouple and thermogenerating room located on its both sides, and ignition biosencing electrode is also fixed over it. The gas fuel unit 4 represents metal plate 5 ( frontal leaf) with the side outer of which the gas spray header 7 is fixed, and the main burners 19 are placed on the inside against flow diffusers. the bunch of heat recovery system tubes that connects furnace to the air-gas flow path’s upper part – the combustion products’ intake tank 3 is located over a furnace, in the upper part of which there is a special branch pipe for сombustion products’ organized tapping into a chimney.

#Heating iunit stabilizers free#

The heat recovery unit is manufactured so that there was large free space limited from the back and to each side, forming the furnace 2 in its lower part. There is water in one of them (heated medium), and moving combustion products (gas air environment) in the other. The copper’s heat recovery system represents sheet steel and pipes pieces welded construction which form two cavities which are not connected among themselves. All basic elements of the device are fixed in its single case which is structurally unites fire-tube the heat recovery system 1, furnace 2, combustion products’ intake tank 3 and gas fuel unit 4. The device, executed in form box-type structure form, is intended for floor-level installation near the outer wall.

The KT20 TS(P2), KT 20 TB(P2) and KT30TS(P2) devices major components, parts and details are presented on figure 2. The main knots, parts and details the devices of KT 8 TS(P2), KT 10 TS(P2), KT 10 TB(P2), KT 12 TS(P2), KT 12 TB(P2), KT 16 TS(P2), KT 16 TB(P2) are presented to in figure 1.

gas-oil unit with autogenous automatic equipment.

heat recovery systems with furnace and combustion products’ intake tank.

TECHNICAL SPECIFICATIONS OF BOILER KT TS/TB(P2) V,G «STANDARD» Copper heat recovery system’s thermal capacity does not exceed the unit’s nominal heat output. By placing main body’s special design copper exchanger into water cavity it is possible to produce hot water for household needs. KT TV(P2) with the steel heat double-circuit recovery system devices are intended water heating in water heating systems and water heating for hot water supply (with copper heat recovery system’s bypass duct). Household heating gas devices with KT TS(P2) steel heat recovery system are intended for water heating in water heating systems only. KT TS(P2) and KT TV(P2) devices are intended for heat supply of individual houses, apartments and constructions of household appointment supplied with natural or artificial circulation water heating systems of the heat carrier with the working pressure of water up to 0,2 MPa (2 bars) and the maximum water temperature at the exit from a copper to 900C.